Mesurement tool
-
Micrometer-comparator with special feeler to measure the pieces fixed in the tower, capacity up to 10 mm. Watchmaking steel
4296
with special contact pointsDesigned for measuring diameters and shoulders of pieces fitted to
the lathe.
Range: 10 mm. Graduated: 0.01 mm. -
Flexible rule in gray chromed stainless steel. length 150 mm
5229
Stainless steel - Grey chromed 150 mm
-
Vertical micrometer with non -rotating spindle stop, capacity from 0 to 25 mm, stop Ø 1.00 mm
5436-A
Range: 0 - 25 mm. Reading 0.01 mm. Mat chromed drum Ø 29 mm. Table in hardened steel.
-
Support for dial gauges
5931
Capacity: 70 mm. Gauge adjustment: Ø 8 mm. Base: 75 x 125 x 32 mm. Total height: 180 mm. Regulation screw. Interchangeable table No 5931-D in ...
Capacity: 70 mm. Gauge adjustment: Ø 8 mm. Base: 75 x 125 x 32 mm. Total height: 180 mm. Regulation screw. Interchangeable table No 5931-D in ...
-
-
Table with revolver plate
5931-DE
Table made of hardened and ground steel table. Revolver plate made of hardened and ground steel, 25 holes (Ø 0.2, 0.25, 0.3, 0.35, 0.4, 0.45, 0.5, 0....
-
Vernier slide foot, graduation from 0.05 mm to 1/128 inches, capacity 150 mm length 232 mm
6045-09
Vernier graduation: 0.05 mm - 1 : 128 inches.
Range: 0 - 130 mm. Length: 210 mm. -
Sliding Caliper in Plastic with dial for watchmaker's
6621
In plastic. Range: 0 - 150 mm and 0 - 6 inches.
Dial graduation: 0.1 mm. 1 turn of hand: 10 mm.
Division rule: 1/16 inch. Length: 224 mm. -
Horizontal micrometer with rotating stop, cylindrical keys in hard metal, Ø 2.00 mm
6734
Range: 0 - 15 mm. Direct reading 0.01 mm. Cylindrical spindles in hard metal Ø 2 mm, No 6736-12. Drum mat chromed.Others spindles available on ...
-
Curved micrometer with rotating stop, cylindrical keys in hard metal, Ø 2.00 mm, capacity from 0 to 25 mm
6735
Cylindrical spindles in hard metal Ø 2 mm, No 6736-12.
Others spindles available on request. See table page No 1044.
- Category
-
- Caliper for lugs (3)
- Dial gauge (28)
- Dixième-gauge (0)
- Inox rulers (6)
- Measurement spindles "4 Points" (4)
- Micrometers with gauge (45)
- Sliding caliper (12)
- Standardized feeler-spindles (0)
